Replies
Shafts Or Gears Or Failures
Posted on
26. Dec. 2012 - 12:26
These could be low to high alloy carbon steels, of proven & documented quality, heat treated as required by material & operational parameters and surface hardened (case hardened) at gear surfaces and/or in in areas of wear contact.
In general, that's commomplace, so pls. provide more input --> failure? / shaft problem or gear problem / information about what you have in your hand.
Regards
R. ■
Gearbox Shaft Failure
Hello,
What is the recommended material for the gears in the gear-box? ■