RFP - Biomass Power Plant

Author
(not verified)
Posted in: , on 2. Jul. 2002 - 17:03

Dear, Sir

We, Consultant of Technology (COT) are working on a biomass power plant project. As we are estimating project cost for Power Plant using palm oil milling waste as a fuel. We then would like to request for proposal (RFP) to supply, manufacturing, fabrication, erection and commissioning of one steam boiler on CIF basis at Krabi Province, Thailand

The data for the boiler are as follows:

1. Design Condition

TypeStoker Firing

Number to be furnishedOne (1) set

Steam flow rate capacity

Maximum continuous rate (MCR)25,000 kg /h

Steam pressure

Design pressure91 kg /cm2g

Superheater outlet70 kg /cm2g (1000 PSLg)

Steam temperature (MCR)

Superheater outlet513 oc (950 oF)

Ambient air condition

Ambient air temperature35 oc

Relative humidity

Firing system

Draft systemForced draft

Steam temperature controlFeed water spray

System

FuelPalm Shell and Palm Fiber

Lower Heating Value

Shell15,700 KJ / kg

Fiber13,900 KJ / kg

Your proposal shall include with the design of fuel feed system.

Your attention in responding to this inquiry is highly appreciated.

Should you require any further information, please contact the undersigned.

Yours sincerely,

Vichai Skulvessaanant

Project Coordinator

E-mail: m-e@cot.co.th

Website: www.cot.co.th

Remarks: 1. Your standard size/designs of boiler/steam turbo-generator close to the required conditions can be also proposed as alternatives as well, such as 3-8.5 MW rating, etc.

2. Should this letter is not coming to the right department kindly forward to the relevant department.

Write the first Reply