Ammonium Nitrate Grinding
A clean simple way to reduce this product, with low HP requirements per ton is our CIM Pin Mill. Please contact me if you are interested in learning more about the Munson Pin Mill for your application requirements.
I look forward to hearing from you.
Best regards,
Charlie Divine
Munson Machinery Co.
315-797-0090 ext.
cdivine@munsonmachinery.com ■
Untitled
This sounds like a hammer mill application, using low tip speed and fixed hammers to reduce fines generation and horsepower consumption. ■
Re: Reduction Of Ammonium Nitrate Particles
A single high roller mill may fit your application. We have tested Ammonium phosphate and sulphate, but not nitrate. If you could send a sample along with MSDS information we will run the product through a mill in our test lab and forward results.
Sincerely,
Dean A Fiechter
A.T. Ferrell Co. Inc.
1440 South Adams Street
Bluffton, IN 46714
1-800-248-8318 ext 46
dafiechter@atferrell.com ■
Reduction of Ammonium Nitrate Particles
What is the best way of reducing Ammonium Nitrate particles from approx 5mm to 2.8mm, at a tonnage of 8100kg/h with good efficiency? ■