Replies
Login to add a Reply

Re: Feed Splitter After Cyclone

Posted on 29. Aug. 2006 - 02:28

A fabrication with an adjustable center plate is all you really need unless you are looking for a significantly accurate level of split.

Regards ■

Re: Feed Splitter After Cyclone

Posted on 29. Aug. 2006 - 05:45

Yes, I am looking for an accurate feed split. Please let me know any vendors for this type of equipment.

Thanks. ■

Feed Splitting Method

Posted on 29. Aug. 2006 - 05:20

If your accuracy requirements are not less than +/- 1%, you may consider using two identical rotary valves under the cyclone. Rotary valves should be flood-fed by maintaining a material level in the cyclone and should have variable speed drives to allow speed adjustment. Run the rotary valves at the same speed, with speed and the level switch interlocked to maintain a constant level in the cyclone. Feed rate from each rotary valve will be = bulk density x valve displacement.

Regards,

Amrit T. Agarwal

Consulting Engineer

Pneumatic Conveying Consulting

Email: polypcc@aol.com

Ph and Fax: 304 346 5125 ■