Grinding And Coating Of Minerals
OME Malaysia has for mission the engineering of-the art ultra-fine classifying, grinding and coating of minerals.
We are dedicated to produce air classifiers, pin-mills, ball-mills and wet pearl mills.
Constant innovation on our classifiers has lead to sharper cuts, less maintenance and the ability to produce minerals of d98<8µm.
We can supply you with finest quality equipment at a good price we have experience in the field and had already installed many plants in Malaysia, Thailand and Saudi Arabia.
Please fill free to send your enquiries and we will be happy meet you and discuss your project.
Hayayoo@yahoo.com
Marketing Manager ■
Re: Crushng Limestone To 40 Mesh
Originally posted by minetec
we are mining limestone lums of size 200 mm to 300 mm .we want to size reduction below 30 mesh powder.at present we have jaw crusher .what kind of grinding media will help us to go further to 30 mesh powder with lower cost .we what 10tones/hr capacity plant.it should be mobile crusher plant witch we are using in mines site.please give us suitable suggestion
Look at a Spokane Crusher-centrifugal crusher
for your project they can be trailer mounted
with a diesel power plant for crusher drive
and it is completely self contained with
oversize recrushing to thirty mesh.
google (spokane crusher) ■
Re: Crushng Limestone To 40 Mesh
The fineness of 30 mesh is approximately equal to 97 % < 600 micron. Provided that the limestone has a content of less than 0.5 % free Silica. An impact mill can be easily used.
For more information please contact:
Robert Rosen
r.rosen@alpine.hosokawa.com ■
Control Screening
Dear Sir,
You'll probably would like to control screen your product.
Recently we have been running control screening with lime over 500 micron (35 mesh) with capacity of 25 TPH, using a 1.7 square meter of screening area.
It is efficient and effective.
If you are interested, you can send me an email: mandil@kroosh.com
or visit our site:
www.kroosh.com
Best Regards, ■
Vsi Impact Crusher Will Do Job Nicely
limestone is a beautiful product to be produced in a VSI (vertical shaft impactor)
COST per ton is not highly abrasive....will be around .2 cents per ton.........extemely low cost per ton. Limestone impacts and breaks easily, can do up to 600-800 STPH depending on the crusher model picked.
I have sold about 15 of these type of crushers in limestone and sand and gravel and well proven technology.
You are going to yield a nice CUBICAL, ANGULAR product. Pluses...low mtce crusher, easily to use, maintain, operate and change impellers vs other types of devices.
NEGATIVES: can create too many fines.....an UNDESIRABLE thing
THIS is a rock on steel VSI) if abrasions is a factor use a ROR rock on rock VSI instead.
................
a high speed cone CRUSHER IS another excellent choice for this job......and will control the bottom end or excessive fines creation much better than a VSI typically.
...................
The choice then becomes.......the capital cost of the two modes of crushing.....a HI SPEED CONE.......will be generally about twice the capital cost of a VSI....to do the same job.
........................................... ■
Crushng limestone to 40 mesh
we are mining limestone lums of size 200 mm to 300 mm .we want to size reduction below 30 mesh powder.at present we have jaw crusher .what kind of grinding media will help us to go further to 30 mesh powder with lower cost .we what 10tones/hr capacity plant.it should be mobile crusher plant witch we are using in mines site.please give us suitable suggestion ■