Antworten
Re: Gate For Unloading Ore Bin
Erstellt am
19. Dec. 2002 - 12:28
Mr. Alarcon,
I work for an engineering firm in Canada that has had the opportunity to design a number of truck loading facilities over the years.
Our company has attempted the design of our own discharge gates but have found a company operating out of the US that can provide a superior gate at a reasonable cost.
I am assuming the bin that you are designing has a conical bottom configuration with a discharge opening of approximately 600 mm in diameter.
The firm Pebco, www.pebco.com, can either custom build to suit your specifications or supply an "off-the-shelf" gate that may alos satisfy your needs.
I hope this helps.
Regards,
Blaine R. Ross
Mining / Materials Handling
UMA Engineering
rossb@umagroup.com ■
Gate for Unloading Ore Bin
Good morning Dr. Reinhard,
My name is Gustavo Alarcn, I work in a Mechanical engineering company and
I´m writing because one engineer in the company told me about you.
Actually I´m working in a project that involves a bin, the capacity is 100
metric tons, and its contents will be laterite ore with sizes between 2" and
3" with irregular shapes. I would like to know if you have any advise
regarding the most suitable type of gate for unloading the bin.
The ore will be unloading from the bin to a 50 ton truck.
I´d like to thank you in advance for your attention and if you have any
comment about my question this will be very much appreciated.
Best regards and have a very good day.
Gustavo Alarcn
Projects Engineer
INDISA S.A.
galarconp@indisa.com.co ■